Search found 6 matches

by wiserorb
Thu May 02, 2019 7:11 pm
Forum: General Discussion
Topic: Low voltage on all pins, even 5v and 3.3v [RESOLVED]
Replies: 10
Views: 17202

Re: Low voltage on all pins, even 5v and 3.3v

You are right. After a bit of research I discovered that my board as a wrong serygraphy for that pin.
As you say that pin is the CMD pin.
Thank you for the help
by wiserorb
Wed May 01, 2019 5:09 pm
Forum: General Discussion
Topic: Low voltage on all pins, even 5v and 3.3v [RESOLVED]
Replies: 10
Views: 17202

Re: Low voltage on all pins, even 5v and 3.3v

Ok, after some serious headache I got it.
If I take the ground on the GND-pin near 5v I get all those strange measurement, but if I take it in the other side of the board i get the full volts I'm expecting.
Do you have some explanation of this behavior?
P.S this happens on both board I have
by wiserorb
Fri Apr 19, 2019 11:14 am
Forum: General Discussion
Topic: Low voltage on all pins, even 5v and 3.3v [RESOLVED]
Replies: 10
Views: 17202

Re: Low voltage on all pins, even 5v and 3.3v

I mean that it doesn't restart, it prints out the things that it has to print, it has no problem except that low voltage thing. I get the same lectures (1.8v on 5v pin and 0.4v on 3.3v pin) whit hello word and after i erased the board. Now i'm going to buy a new one, and check if the problem is limi...
by wiserorb
Thu Apr 18, 2019 12:12 pm
Forum: General Discussion
Topic: Low voltage on all pins, even 5v and 3.3v [RESOLVED]
Replies: 10
Views: 17202

Re: Low voltage on all pins, even 5v and 3.3v

Ok, I both erased and flashed idf hello_word in the board, but I get the same results. In the console there isn't any reboot.
I tried to power the esp32 with a PC port and a wall adapter with 2 ampere, but nothing changed. However programs run flawlessly.
by wiserorb
Tue Apr 16, 2019 6:41 pm
Forum: General Discussion
Topic: Low voltage on all pins, even 5v and 3.3v [RESOLVED]
Replies: 10
Views: 17202

Re: Low voltage on all pins, even 5v and 3.3v

OH yes, that was an experimental change to find a solution . If I put the gpio as OUTPUT i get the same results
by wiserorb
Sun Apr 14, 2019 3:54 pm
Forum: General Discussion
Topic: Low voltage on all pins, even 5v and 3.3v [RESOLVED]
Replies: 10
Views: 17202

Low voltage on all pins, even 5v and 3.3v [RESOLVED]

Hi, I was trying to power a simple led, but when I set the output high it flickered. So i measured the voltage whit an external multimeter and it said 0.3v! So I tested the voltage on 5v and it was 1.8, on 3.3v was 0.3. Despite this the board was in softAP mode and communicating with the computer. P...