I have a D 32 using the DAC going to an amplifier out to my speaker when I have a power switch in between to turn the speaker on and off when the speakers off I don’t have any audio feedback or popping noise when I turn it on. It is constant rapid succession of a pop noise. I put a capacitor between ...

I need to have the ability to connect to both Wi-Fi and Bluetooth simultaneously. I wanted to use the ESP 32 and add a second radio module. My thought is the ESP 32 would handle the Wi-Fi connection and then the module would connect directly to a Bluetooth speaker..



I originally had used a Wemo ...

I have code that runs on a d1 mini. My d1 mini is then wired to the d32 3v, ground and from the d4 on mini to d16 on the d32. I had to do this originally because I was using the d1 for WiFi and later needed to add Bluetooth and this was the easy solution,

Now I have got to the point that I’d ...

our issue is as follows we are wemos D1 pin d4 connecting to a D 32 with pin 16 and the power from the
D 32 is coming off the 3.3 V and ground on the d1 when we powered that way with the USB being plugged into the D1 we cannot make a connection to a Bluetooth speaker without pressing the reset ...

it belongs to the v3.2 branch, so I thought I could just simply get the commit and add arduino-esp32 as a component compile and get all the libs necessary. but its simply not working.
the fix implemented on the commit mentioned above works perfectly but unfortunately is restricted only to esp-idf at ...

I do power it with 3.3v. Have tried with. 5 v also same problem

Only time I don’t have problem is if I power into micro usb


I’m not using WiFi I know they can’t coexist

The problem resolved if I push reset on board I have used a cap from en to ground thst did nothing

here is the data from serial monitor on the d32 here is what we did

i load code on d32

then load our code on d1 only connection between the 2 is on pin 16 on d32
our device connects to speaker but no sound
then i press our test button on our config page our light works but no sound
then i press ...

our issue is as follows we are wemos D1 pin d4 connecting to a D 32 with pin 16 and the power from the
D 32 is coming off the 3.3 V and ground on the d1 when we powered that way with the USB being plugged into the D1 we cannot make a connection to a Bluetooth speaker without pressing the reset ...