Hello, I get this Warning when compiling. I am not exact sure if i can move some partitons (and how) or if I need a larger ESP Dev. LowSpace.png And this is the compile restult: SpacePart2.png I am Using the ESP32-WROOM-32E but don´t know how much Flash I got. I guess 4MB but how can I check the mod...

Hello, for an LED Matrix I need to talk to an TLC6983 Chip with an CCSI Frame format. This means "Continuous Clock Serial Interface". Looks like this: ccsi.png Clock needs to be present all the time as the matrix chip has no clock internally but uses the input clock signal from the host device to sc...

Thanks for all the efforts.

I found, that the Solo Crashes because of mem issues and core issues.
I set Single Core operation in RTOS and reduced heap size for tasks.

Now it is working as expected!

Best regards

Thanks for your reply...
I am using an

ESP32-SOLO-1

Thanks

Hello,

right after Boot, the PIN14 outputs a PWM signal.
But I need to use this pin as normal PushPull Output.

How can I remove the PWM signal? Nothing I found in the forum helps (gpio_reset_pin() or ledc config).

Can someone help me please?

Best regards

Got it... was my own fault.

I tried to reference a static function

Move along - nothing to see here.

We created a project from the blinky example. And we added an own component to that project like this: 01.png so the component itself uses i2c so I added following lines to CMakeLists.txt: [Codebox] idf_component_register(SRCS "mc_adau1701.c" INCLUDE_DIRS "." REQUIRES driver) [/Codebox] Editor shows...

My workaround at the moment is to change the prescaler of the mcpwm module directly in the idf driver folder: MCPWM.png However, this is not the best solution as the IDF should not be changed permanently because of updates etc. But one suggestion: If the DEVs put in a #ifndef / #define a user could ...

It seems that you have tied the "BOOT_SEL" pin to GND. Than the ESP32 boots in download mode for flashing new firmware. Make sure the Boot_SEL Pin is high or floating to boot in normal operation mode. Here you can find all the boot messages. https://github.com/espressif/esptool/wiki/ESP32-Boot-Mode-...

I need a complementary PWM with dead time generation of 150 kHz. Here is a quality graph of the PWM Signal I need. Duty Cycle needs to be 50 % and frequency 150 kHz. PWM.png So I thought I use the MCPWM module for that, but I recognized that the maximum frequency is about 2 kHz. When going higher th...