Search found 1165 matches

by WiFive
Sat Nov 25, 2017 2:32 am
Forum: ESP32 SDK
Topic: TCP Slow, then disconnects, UDP Slow
Replies: 4
Views: 36

Re: TCP Slow, then disconnects, UDP Slow

Did you try a make erase_flash before switching to 3.0?
by WiFive
Fri Nov 24, 2017 7:29 am
Forum: ESP32 SDK
Topic: TCP Slow, then disconnects, UDP Slow
Replies: 4
Views: 36

Re: TCP Slow, then disconnects, UDP Slow

Try 3.0-dev version i think there are some phy fixes for 26mhz crystal that sparkfun uses
by WiFive
Sat Nov 18, 2017 8:10 pm
Forum: ESP32 SDK
Topic: Possible to use RMT for simultaneous input and output on the same gpio line, for 1-wire?
Replies: 6
Views: 128

Re: Possible to use RMT for simultaneous input and output on the same gpio line, for 1-wire?

Rmt_set_pin for TX will enable the output driver by default, so you could immediately disable it or rewrite the tx pin setup
by WiFive
Sat Nov 18, 2017 3:55 am
Forum: ESP32 SDK
Topic: Possible to use RMT for simultaneous input and output on the same gpio line, for 1-wire?
Replies: 6
Views: 128

Re: Possible to use RMT for simultaneous input and output on the same gpio line, for 1-wire?

Active drive is probably only a problem with multiple parasite power devices doing simultaneous conversions.

But you should enable open drain mode in init either way.
by WiFive
Sat Nov 18, 2017 2:13 am
Forum: ESP32 SDK
Topic: Possible to use RMT for simultaneous input and output on the same gpio line, for 1-wire?
Replies: 6
Views: 128

Re: Possible to use RMT for simultaneous input and output on the same gpio line, for 1-wire?

Why heavily modified? Why did you take out the open drain, active drive stuff?

Go to advanced search