Hi,
Thanks for your reply. We have already installed a 10uF capacitor between 3.3V and Ground line.


Regards,
Jagan K

Hi team,
We have designed a project using the ESP32-C6-MIN-1 and we are trying to connect the module to a router(NETGEAR).

Our device enters deep sleep and wakes up periodically every 5 minutes. However, the connection is inconsistent—sometimes module connects successfully to WiFi using the saved ...

Hi,
Thanks for your reply.
We are using the single Power supply LDO of 3.3V/500mA. We have placed the Decoupling capacitors and LDO nearer to the ESP Module, attached the image for your reference.
And for antenna section, we have used the ESP32-C6-MINI-1-N4 in our design. We have provided a PCB cut ...

Hi,
We are planning on a project using the ESP32-C6 MINI module and designing the Power Section with 3.3V/0.5A LDO as per the datasheet.
While checking the ESP32-C6 Devikit, the power deigned with 3.3V/800mA.
During our development with 3.3V/0.5A design, we faced continuous BOD reset during WiFi ...

Thanks for your Response.
GPIO8 is kept floating. Do i need to connect this pin to HIGH logic?

Can you please share the software that can be used? And for development, we are fine with GPIO9 accessible, but we are looking for production setups. If you got any suggestion, pls share.


Regards,
Jagan K

Hi Team,
We are using the ESP32-C6 in our project and attempting to enter Boot mode by asserting GPIO9 to LOW. However, every time we try, the device enters either SPI Boot or Download or SDIO Boot. Since we are only using UART Boot for our project, we want to disable SPI Boot and SDIO Boot in our ...