I have downloaded the camera webserver example code via the Arduino IDE and it works fine. I would like to start/stop the video stream from the ESP32 code itself (demo uses a button on the web page) using a switch on a ESP32 GPIO pin.
Nowhere in the code can I see where the video stream is turned ...
Search found 3 matches
- Wed Jul 24, 2019 5:36 pm
- Forum: General Discussion
- Topic: ESP32-EYE- starting/stopping video stream using a switch on ESP32 board
- Replies: 0
- Views: 3071
- Mon Sep 25, 2017 6:32 pm
- Forum: General Discussion
- Topic: RMT in loop mode results in crash, and no looping for 64+ items
- Replies: 2
- Views: 5549
Re: RMT in loop mode results in crash, and no looping for 64+ ite
I experienced same issue when using RMT transmit , but from Arduino IDE code. The NECSend example from Espressif, I was following used malloc to allocate the item array, but did not include a free(Item) after the call to rmt_write_items. After I added this, the crashing stopped. You have to use the ...
- Mon Sep 25, 2017 5:34 pm
- Forum: Sample Code
- Topic: Alternative to ESP_ERROR_CHECK
- Replies: 5
- Views: 14377
Re: Alternative to ESP_ERROR_CHECK
Hi Neil
This is off topic: I love your book. Have used it on several projects, the latest being a learning IR remote/ wifi blaster using RMT peripheral. I note on page 255 you show max values of 65535 for the 15- bit timing value saved by the RMT peripheral. This should be 32767.
Using the Arduino ...
This is off topic: I love your book. Have used it on several projects, the latest being a learning IR remote/ wifi blaster using RMT peripheral. I note on page 255 you show max values of 65535 for the 15- bit timing value saved by the RMT peripheral. This should be 32767.
Using the Arduino ...