Search found 5 matches
- Tue Feb 25, 2020 3:28 pm
- Forum: ESP32 Arduino
- Topic: ISR Timer Interrupt Output and void loop() Output not synchronous
- Replies: 0
- Views: 1236
ISR Timer Interrupt Output and void loop() Output not synchronous
Hello, I want to realize a serial synchronous data exchange with GPIOs "by hand". My CLOCK is in a ISR-Timer Interrupt Service Routine and GPIO23 with LED1 at 1Hz. The DATA line is on GPIO22 with LED2 and is performed in void loop() with a pattern stored in an array. Starting the programm the follow...
- Tue Jun 11, 2019 4:27 pm
- Forum: General Discussion
- Topic: Hi , is there any sample code to interface the mpu-6050 with the esp32 ..??
- Replies: 10
- Views: 10580
Re: Hi , is there any sample code to interface the mpu-6050 with the esp32 ..??
Hi there,
C-programm is ok - but, do you have an .ino code file to use it with the Arduino IDE an ESP32 DevKitC Board to get data from the MPU6050? It can be very simple for understanding
- perhaps with the right .h- and .cpp-files?
Thanks!
Oli
C-programm is ok - but, do you have an .ino code file to use it with the Arduino IDE an ESP32 DevKitC Board to get data from the MPU6050? It can be very simple for understanding

Thanks!
Oli
- Sun Jun 03, 2018 7:46 pm
- Forum: General Discussion
- Topic: ESP32: Get back to SSC-command mode?
- Replies: 2
- Views: 1445
Re: ESP32: Get back to SSC-command mode?
Thanks for answer. I am new in business and just downloaded the Flash Tool from espressif, but unfortunatelly I can't find the relevant ssc binary file. Can you provide a link?
- Sun Jun 03, 2018 11:45 am
- Forum: General Discussion
- Topic: ESP32: Get back to SSC-command mode?
- Replies: 2
- Views: 1445
ESP32: Get back to SSC-command mode?
I programmed the ESP32 WROOM with the Arduino IDE. It works perfectly. But, how do I get back to the SSC Mode to apply SSC commands?
- Thu May 31, 2018 7:21 pm
- Forum: General Discussion
- Topic: Fault at PowerON: +JAP:DISCONNECTED,0,201
- Replies: 0
- Views: 921
Fault at PowerON: +JAP:DISCONNECTED,0,201
My esp32 node always shows +JAP:DISCONNECTED,0,201 after startup and shows it continously, I have no access via terminal.
Is there hardware reset option? Unplugging and a plug in doesn't have effect.
Thanks
Oli
Is there hardware reset option? Unplugging and a plug in doesn't have effect.
Thanks
Oli