Code: Select all
IP4_ADDR(&info.gw, 192, 168, 1, 1);//ESP acts as router, so gw addr will be its own addrSearch found 3529 matches
- Thu Feb 28, 2019 8:52 am
- Forum: ESP-IDF
- Topic: internet unavailable when connected to AP(Wi-Fi) of ESP32 DevKit,
- Replies: 18
- Views: 19487
Re: internet unavailable when connected to AP(Wi-Fi) of ESP32 DevKit,
- Thu Feb 28, 2019 12:52 am
- Forum: ESP-IDF
- Topic: WiFi not working
- Replies: 3
- Views: 4537
- Sun Feb 24, 2019 5:59 am
- Forum: ESP-IDF
- Topic: UART WiFi bridge mode, but with I2C?
- Replies: 1
- Views: 2876
Re: UART WiFi bridge mode, but with I2C?
Check out parallel modes of i2s aka camera mode and lcd mode.
- Sat Feb 23, 2019 12:12 pm
- Forum: ESP-IDF
- Topic: internet unavailable when connected to AP(Wi-Fi) of ESP32 DevKit,
- Replies: 18
- Views: 19487
- Fri Feb 22, 2019 7:42 am
- Forum: Hardware
- Topic: Measure time between signals with MCPWM capture
- Replies: 6
- Views: 8978
Re: Measure time between signals with MCPWM capture
He's not talking about the internal hall sensor but an external one that is mounted on a motor shaft.
- Wed Feb 20, 2019 5:52 am
- Forum: General Discussion
- Topic: eth_clock_mode_t for ESP32 WROVER
- Replies: 3
- Views: 3929
Re: eth_clock_mode_t for ESP32 WROVER
WroverB has a provision internally to not use gpio 17 with the new 8mb psram but I don't know if it has ever shipped in this configuration or if the signal is even routed to the pad.
- Tue Feb 19, 2019 9:38 am
- Forum: General Discussion
- Topic: restoring gpio to normal after waking up from deep sleep
- Replies: 2
- Views: 4467
- Tue Feb 19, 2019 1:46 am
- Forum: ESP-IDF
- Topic: AP to APSTA without loosing AP client
- Replies: 3
- Views: 4161
Re: AP to APSTA without loosing AP client
If it has to change channels then yes, client will have to reconnect on the new channel.
- Mon Feb 18, 2019 4:44 am
- Forum: Hardware
- Topic: I2S Audio Codec Master Clock
- Replies: 1
- Views: 3316
- Mon Feb 18, 2019 4:27 am
- Forum: Hardware
- Topic: Esp32 connected to 1-wire overheats and burns board
- Replies: 7
- Views: 7843
Re: Esp32 connected to 1-wire overheats and burns board
Most 1-wire devices can work at 3.3v