Having issues with Dual RS232-HS drivers

orbitcoms
Posts: 141
Joined: Fri Aug 03, 2018 10:08 pm
Location: Sydney, Australia

Having issues with Dual RS232-HS drivers

Postby orbitcoms » Thu May 13, 2021 8:42 pm

I was working with the Dual RS23-HS (on the ESP_PROG programmer) for a while just using serial com for flashing and monitoring in vscode (Interface 1 as com port)

Yesterday I wanted to look at using debugger with JTAG so I attached the ESP32-WROVER-KIT v 4.1 and the software could not find the debugger port (Interface 0).

I followed online advise to use Zadig to configure interface 0 as winusb but this did not work. Somehow I also managed to change driver on interface 1 and now cannot flash and monitor via serial port anymore. I have fiddled around trying to get it to work again and cannot. In windows it is shown as "Dual RS232-HS(Interface 1) COM17. Before is was simply "COM16". I have a setup at home also that still works using serial port and not that interface 1 driver is set up as HIDUSB.

Can someone please explain
1. How I can get my interface 1 set up properly as com port again
2. How to set up interface 0 for it to be found in vscode for debugging using openocd?

Thanks

pqkhanh561
Posts: 1
Joined: Mon Feb 14, 2022 4:19 am

Re: Having issues with Dual RS232-HS drivers

Postby pqkhanh561 » Mon Feb 14, 2022 4:21 am

I have same issue. Any help! Thanks!

Who is online

Users browsing this forum: No registered users and 44 guests