WROOM32 holding TX/RX at 3.3V?

romoko
Posts: 1
Joined: Sun Dec 02, 2018 1:30 am

WROOM32 holding TX/RX at 3.3V?

Postby romoko » Sun Dec 02, 2018 1:40 am

Hi I've made a PCB with a WROOM32 module on it. However, once powered, the TX/RX (and EN) become pinned at 3.3V. See picture below.
Capture.PNG
Capture.PNG (14.24 KiB) Viewed 344 times
I haven't been able to find any documentation on this boot state online. Reproduced on two WROOM modules, so it must be something I'm doing.

Any help would be appreciated.

Who is online

Users browsing this forum: ESP_Dazz, Jye___ and 10 guests