WROOM32 holding TX/RX at 3.3V?
Posted: Sun Dec 02, 2018 1:40 am
Hi I've made a PCB with a WROOM32 module on it. However, once powered, the TX/RX (and EN) become pinned at 3.3V. See picture below.
I haven't been able to find any documentation on this boot state online. Reproduced on two WROOM modules, so it must be something I'm doing.
Any help would be appreciated.
- Capture.PNG (14.24 KiB) Viewed 1993 times
Any help would be appreciated.