ESP32 CAM problem tu run module

ingegus
Posts: 2
Joined: Sat Jul 20, 2019 11:55 pm

ESP32 CAM problem tu run module

Postby ingegus » Sun Jul 21, 2019 12:14 am

Need help, i buy three modules of ESP32-CAM, to program i use the module USB-TTL HW-597, the compilation and the load of code is ok but don't run when i open the control monitor apear this

"rst:0x7 (TG0WDT_SYS_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x08,d_drv:0x04,cs0_drv:0x08,hd_drv:0x0a,wp_drv:0x00
mode:DIO, clock div:1
load:0x3fff0058,len:303051012
1162 mmu set 00010000, pos 00010000
1162 mmu set 00020000, pos 00020000
1162 mmu set 00030000, pos 00030000
1162 mmu set 00040000, pos 00040000
1162 mmu set 00050000, pos 00050000
1162 mmu set 00060000, pos 00060000
1162 mmu set 00070000, pos 00070000
1162 mmu set 00080000, pos 00080000
1162 mmu set 00090000, pos 00090000
1162 mmu set 000a0000, pos 000a0000
1162 mmu set 000b0000, pos 000b0000
1162 mmu set 000c0000, pos 000c0000
load:0xffffffff,len:-1
ets Jun 8 2016 00:22:57
"
any one know what can i do?

ingegus
Posts: 2
Joined: Sat Jul 20, 2019 11:55 pm

Re: ESP32 CAM problem tu run module

Postby ingegus » Mon Jul 22, 2019 5:20 pm

Hi gays i think my problem begin to resolving, i was puting the electrical power supply to 3.3 vdc i change to 5 vdc and now i think is ok.

Who is online

Users browsing this forum: No registered users and 2 guests