How to generate Uart Break signal?

hansys65
Posts: 1
Joined: Tue Aug 13, 2019 12:27 am

How to generate Uart Break signal?

Postby hansys65 » Tue Aug 13, 2019 6:41 am

Dear Sir/Madam,

I want to try make UART break signal, But I can't.

If I set UART TX line mode to GPIO and output state to low. After the finish break operation It can't return to UART operation mode So, it can't be use.

So how can I make UART break signal on EPS32 Arduino mode.

Thank you

Hyeon-Cheol Park
Hyeon-Cheol Park

Who is online

Users browsing this forum: No registered users and 4 guests