Page 1 of 1

ESP_RF_Test_tool upload error

Posted: Wed Jan 13, 2021 11:32 pm
by Panometric
The lab is scheduled, but the test tool will not upload over serial.
I can only assume it's because it changes the baud rate for upload from what is selected 115200 to 921600 which is more than my FTDI cable can support.


Code: Select all

ESP_MAC: 00:00:00:00:00:00
Uploading stub...
Running stub...
Stub running...
Changing baud rate to 921600
start to load
Flash params set to 0x0220
Compressed 197552 bytes to 115549...
GUI Log:

Code: Select all

sync success
load start
load bin fail
Is there a way to set the upload baud?
OR should I just load the BIN another way and not use this feature?