Hints on pulling GPIO0 low from Geekcreit DOIT v1 dev board.

divinergregg
Posts: 2
Joined: Wed Nov 01, 2017 2:32 pm

Hints on pulling GPIO0 low from Geekcreit DOIT v1 dev board.

Postby divinergregg » Wed Jan 09, 2019 12:16 am

Bought the geekcreit esp32 dev v1 board a year ago and didn't have to hold the boot button down to download a new program.

Purchased a bunch more this month and now I do have to hold the boot down when downloading from the Arduino IDE. Pain.

I have read the "esp32 boot mode selection" page, but I don't know how to modify my board to get the new boards to behave like the older versions.

https://github.com/espressif/esptool/wi ... -Selection

**note, GPIO2 is the "built in LED".

This is the board
https://www.banggood.com/ESP32-Developm ... rehouse=CN

1) What is the exact pin label to solder to Gnd?
2) Is that all
3) can I just jump the boot button and will the programs run when supplying power (like it did with my older v1 doit boards?



Thanks !

Who is online

Users browsing this forum: Bing [Bot] and 12 guests