Please help

Exxteban
Posts: 1
Joined: Sat Jan 18, 2020 3:14 am

Please help

Postby Exxteban » Sat Jan 18, 2020 3:32 am

Hello friends, i have a esp32 Wroom DoIt DevKit v1 with a Ds18b20, to which I connect to the computer's USB and send the information in this case to ThinkSpeak the temperature without any problem, but when connecting to the VIN pin and the GND of the LiFePo4 battery, it turns on the Red Power LED, but does nothing, not even the wifi connects, does not send the temperature, does nothing, just turns on, but by the USB if you send the data to Thinkspeak, I do not understand what the problem may be.

I have 2 Esp32 same and the same happens to me with both. :cry:
Attachments
IMG_20200118_003003 (1).jpg
IMG_20200118_003003 (1).jpg (1.93 MiB) Viewed 4990 times

mikemoy
Posts: 599
Joined: Fri Jan 12, 2018 9:10 pm

Re: Please help

Postby mikemoy » Sun Jan 19, 2020 1:56 pm

When you disconnect the USB cable and plug in the battery then press reset does it then work ?
Last edited by mikemoy on Sun Jan 19, 2020 5:48 pm, edited 1 time in total.

Ristridin
Posts: 8
Joined: Sat May 18, 2019 7:38 pm

Re: Please help

Postby Ristridin » Sun Jan 19, 2020 2:13 pm

What is the battery voltage. If 5V or higher: connect to Vin. If 3.3V, connect to 3V3

Who is online

Users browsing this forum: No registered users and 22 guests