Sending commands via JTAG to the esp32.

[CKiamy]

Hello everyone!

For my project I am currently using the ESP32-WROOM-32UE device and a jlink adapter for JTAG flashing and debugging. Is there a way to send a command through a command window via JTAG that is similar to UART? For example, to read information received via UART, we can use the function:

Code: Untitled.c Select all

uart_read_bytes(uart_num, buf, length, ticks_to_wait);

Is there a similar function like this via JTAG? I would like to do some logic in my firmware like:

Code: Untitled.c Select all

while(receivingJtagCommand){

    jtagCommand = jtag_read_bytes(ECHO_JTAG_PORT, data, (BUF_SIZE - 1), 20 / portTICK_PERIOD_MS);

    if(jtagCommand == "Hello"){

        runSpecialTask();

        break;

    }

}

This type of logic can be perfectly done via UART, but is it possible via JTAG? I have tried using the esp_apptrace_read command to no avail, and documentation for this type of application is pretty spotty.

[CKiamy]

Bump

[n47h4n]

Hi,

Did you find a way to do that?
I'm very interesting.

[n47h4n]

Hi CKiamy,

I have found this:

Code: Select all

#include "esp_app_trace.h"
.
.
.
  char buf[32];
  char down_buf[32];
  size_t sz = sizeof(buf);

  /* config down buffer */
  esp_apptrace_down_buffer_config((uint8_t*) down_buf, sizeof(down_buf));
  /* check for incoming data and read them if any */
  esp_err_t res = esp_apptrace_read(ESP_APPTRACE_DEST_TRAX, buf, &sz, 0/*do not wait*/);
  if (res != ESP_OK) {
      log_e("Failed to read data from host!");
  }
  if (sz > 0) {
      /* we have data, process them */
  }

I didn't try it, I'm waiting an esp-prog...