Troublshooting ESP32-S3 WiFi AP

[Will_L]

Having trouble getting a WiFi Access Point to work on a custom S3 board. Identical code on an ESP32-S3-DevKitC-1U works fine. Looking for any suggestions on ways to troubleshoot either hardware or software.

Code: main.cpp Select all

#include <Arduino.h>

#include <WiFi.h>



const char *ssid = "ESP32";

const char *password = "PASSWORD";



void setup() {

	Serial.begin(115200);

	Serial.println("Configure access piont");

	WiFi.softAP(ssid, password);

	IPAddress myIP = WiFi.softAPIP();

	Serial.print("AP-IP Address");

	Serial.println(myIP);

}



void loop() {

}

Development is PlatformIO running on top of Visual Studio Code for editing/building, then flashing using the "ESP32S3 FLASH DOWNLOAD TOOL V3.9.5" utility. For the dev kit I'm using the same source code as above but build/flash using the Arduino 1.8.19 IDE.

Code appears to run fine based on serial prints, but the AP never shows up for either my Windows or Ubuntu laptops. Same code on the dev kit shows up just fine.

Code: serial.txt Select all

ESP-ROM:esp32s3-20210327

Build:Mar 27 2021

rst:0x1 (POWERON),boot:0x8 (SPI_FAST_FLASH_BOOT)

SPIWP:0xee

mode:DIO, clock div:2

load:0x3fce3808,len:0x3ac

load:0x403c9700,len:0x9b4

load:0x403cc700,len:0x2908

SHA-256 comparison failed:

Calculated: c0cf91409b6e8a9ebb3be9aa4bc24145a18278e6c7411fcfc5fd4816f574b49b

Expected: ccbdf521f90ffa902a0f72b4d1bdaa90e077361003a1c152131c93a62b8a7c0e

Attempting to boot anyway...

entry 0x403c98bc

E (233) esp_core_dump_flash: No core dump partition found!

E (233) esp_core_dump_flash: No core dump partition found!

Configure access piont

[   273][D][WiFiGeneric.cpp:1035] _eventCallback(): Arduino Event: 0 - WIFI_READ

Y

[   316][D][WiFiGeneric.cpp:1035] _eventCallback(): Arduino Event: 10 - AP_START



[   321][D][WiFiGeneric.cpp:1035] _eventCallback(): Arduino Event: 11 - AP_STOP

AP-IP Address192.168.4.1

[  1064][D][WiFiGeneric.cpp:1035] _eventCallback(): Arduino Event: 10 - AP_START

[lbernstone]

Is the module mounted on a corner with the right side of the antenna exposed, and nothing underneath it? A quick read through the design guide is a good idea before making a custom board.
Are you able to connect out as a STA to an AP? What sort of RSSI do you get if you run a scan?