Page 2 of 2
Re: Is flash read err, 1000 normal behavior?
Posted: Thu Dec 03, 2020 3:26 pm
by Kashyapkoshti
when i purchased it i used it for 2-3 months and after that one day it suddenly stopped working.
before that i was able to run code for wifi controlled car
Re: Is flash read err, 1000 normal behavior?
Posted: Sun Dec 06, 2020 5:02 pm
by chegewara
Well, this is important info. In that case it may be hardware issue, maybe soldering. I am assuming you didnt touch efuses.
Re: Is flash read err, 1000 normal behavior?
Posted: Mon Dec 07, 2020 3:59 pm
by Kashyapkoshti
I used this board for 4-5 months and after that suddenly one day it spits out this error
after that, it never accepted any code and there is time out for packet error in Arduino IDE
Re: Is flash read err, 1000 normal behavior?
Posted: Wed Dec 09, 2020 4:33 am
by Ritesh
I used this board for 4-5 months and after that suddenly one day it spits out this error
after that, it never accepted any code and there is time out for packet error in Arduino IDE
So, Board is not going into boot mode as well? can you please check with multiple option like remove each and everything and connect back and see board is going into programming mode or not