ESP32 Forum

Posted: **Fri Mar 27, 2020 5:19 pm**

Hi guys,-)

I have a CSI camera attached and IO36, IO39 is used as input for D0,D1.

I cant get readings of the input.

All others are working (2 15 13 12 14 33 34 35 32)

Do i need to disable ADC or Hall sensor or ?

any clues welcome:-)

here my io init and reading:

Code: Untitled.txt Select all

	int i;

	gpio_config_t conf;



	conf.pin_bit_mask=0;

	for (i=0;i<sizeof(pintab)/sizeof(gpio_num_t);i++)

//	gpio_set_direction(pintab[i], GPIO_MODE_INPUT); // doesnt work as expected!

		conf.pin_bit_mask |= 1ULL<<pintab[i]; // set the pin bits for gpio_config to apply below settings.

	

	conf.intr_type = GPIO_INTR_DISABLE;

	conf.mode = GPIO_MODE_INPUT;

	conf.pull_down_en = GPIO_PULLDOWN_DISABLE;

	conf.pull_up_en = GPIO_PULLUP_DISABLE;

	gpio_config(&conf); // we need to do it with gpio_config, otherwise some pins dont work as expected!!!



.....

reading:

		if (pin < 32)

		{

		state = (GPIO_REG_READ(GPIO_IN_REG)  >> pin) & 1U;

		}

		else

		{

			pin -= 31;

		state = (GPIO_REG_READ(GPIO_IN1_REG)  >> pin) & 1U;

		}

Thanks

Posted: **Fri Mar 27, 2020 5:26 pm**

ooouuups.......

i found it.

reading inputs correct version:

if (pin < 32)
{
state = (GPIO_REG_READ(GPIO_IN_REG) >> pin) & 1U;
}
else
{
pin -= 32;
state = (GPIO_REG_READ(GPIO_IN1_REG) >> pin) & 1U;
}

ESP32 Forum

GPIO36,39 as digital input not working

GPIO36,39 as digital input not working

Re: GPIO36,39 as digital input not working