烧录ESP-WROOM-02-AT-V2.2.2.0固件后AT指令没反应
Posted: Mon Jun 09, 2025 2:29 pm
烧录了factory_WROOM-02.bin后发送AT指令没有反应，上电后输出乱码
但是UART1中可以输出日志
使用的是NODEMCU
但是UART1中可以输出日志
Code: Select all
boot: ESP-IDF v3.4-98-gff16a35 2nd stage bootloader[0m
[0;32mI (60) boot: compile time 08:13:35[0m
[0;32mI (60) boot: SPI Speed : 80MHz[0m
[0;32mI (63) boot: SPI Mode : DIO[0m
[0;32mI (67) boot: SPI Flash Size : 2MB[0m
[0;32mI (71) boot: Partition Table:[0m
[0;32mI (75) boot: ## Label Usage Type ST Offset Length[0m
[0;32mI (82) boot: 0 otadata OTA data 01 00 00009000 00002000[0m
[0;32mI (89) boot: 1 ota_0 OTA app 00 10 00010000 000e0000[0m
[0;32mI (97) boot: 2 at_customize unknown 40 00 000f0000 00020000[0m
[0;32mI (104) boot: 3 ota_1 OTA app 00 11 00110000 000e0000[0m
[0;32mI (112) boot: 4 nvs WiFi data 01 02 001f0000 00010000[0m
[0;32mI (119) boot: End of partition table[0m
[0;32mI (123) boot: No factory image, trying OTA 0[0m
[0;32mI (128) esp_image: segment 0: paddr=0x00010010 vaddr=0x40210010 size=0xb4238 (737848) map[0m
[0;32mI (137) esp_image: segment 1: paddr=0x000c4250 vaddr=0x402c4248 size=0x1bb7c (113532) map[0m
[0;32mI (146) esp_image: segment 2: paddr=0x000dfdd4 vaddr=0x3ffe8000 size=0x00788 ( 1928) load[0m
[0;32mI (154) esp_image: segment 3: paddr=0x000e0564 vaddr=0x40100000 size=0x00080 ( 128) load[0m
[0;32mI (163) esp_image: segment 4: paddr=0x000e05ec vaddr=0x40100080 size=0x05a5c ( 23132) load[0m
[0;32mI (172) boot: Loaded app from partition at offset 0x10000[0m
phy_version: 1163.0, 665d56c, Jun 24 2020, 10:00:08, RTOS new
module_name:WROOM-02
max tx power=78,ret=0
2.2.2