ESP32 Forum

Hi,

I am trying to control an integrated stepper motor from NI . I have been reading about using Arduino for the last week. However,It is my first experience with Stepper motor and Arduino and I have two points I need to be sure before I start wiring and programming.

1- Genuino Uno: Is it suitable for generating this signals?

2-Should I worry about the current used for generating the Step and Dir signals?

Regards

1- Genuino Uno: Is it suitable for generating this signals?

Sure.
But since it doesn't use an Espressif (ESP32) microcontroller I'm not sure if you're asking at the right place.

2-Should I worry about the current used for generating the Step and Dir signals?

No.