ESP32C6 multiple ATTEN per unit
Posted: Wed Sep 17, 2025 9:02 am
Hello everyone!
Why is there a check on adc_continuous_config() (IDF v5.5) on whether the attenuations match per unit? Page 1360 of technical reference manual even shows an example of this. Is this due to the calibration driver problems that would arise when doing so?
Why is there a check on adc_continuous_config() (IDF v5.5) on whether the attenuations match per unit? Page 1360 of technical reference manual even shows an example of this. Is this due to the calibration driver problems that would arise when doing so?