Why have a UART to USB bridge?
Posted: Wed Dec 31, 2025 11:23 am
Many Espressif devkits (ESP32-C6-DevKitC-1) include a UART USB bridge, usually the Silicon Labs CP2102N.
Most of the chips (ESP32-S3, ESP32-C3, ESP32-C6) in these devkits can support USB serial communication (standard USB CDC-ACM) easily without use of any other hardware, so it seems like adding a UART USB bridge IC is totally redundant.
Questions
What are the top reasons any hardware developer would add a UART USB bridge IC like the CP2102N to a custom device using a ESP32 MCU that can already support standard USB CDC-ACM?
Is it just to be able to set a custom VID and PID, is that the only benefit to adding a UART USB bridge IC?
Reasoning
I see that Mr @SpriteTM added a UART USB bridge (CH340C) to his PDP emulator custom hardware project, so there must be a good reason to do this. I wonder what would happen to his project if he tried to design it without the bridge chip? It doesn't seem like the bridge IC can support HID or MSC.
Most of the chips (ESP32-S3, ESP32-C3, ESP32-C6) in these devkits can support USB serial communication (standard USB CDC-ACM) easily without use of any other hardware, so it seems like adding a UART USB bridge IC is totally redundant.
Questions
What are the top reasons any hardware developer would add a UART USB bridge IC like the CP2102N to a custom device using a ESP32 MCU that can already support standard USB CDC-ACM?
Is it just to be able to set a custom VID and PID, is that the only benefit to adding a UART USB bridge IC?
Reasoning
I see that Mr @SpriteTM added a UART USB bridge (CH340C) to his PDP emulator custom hardware project, so there must be a good reason to do this. I wonder what would happen to his project if he tried to design it without the bridge chip? It doesn't seem like the bridge IC can support HID or MSC.