Page 1 of 1
ESP32-C5-WROOM and UART1
Posted: Thu Mar 05, 2026 2:49 pm
by rtborg
I need to use RS485 with ESP32-C5-WROOM module. Is UART1 accessible for the WROOM module?
Re: ESP32-C5-WROOM and UART1
Posted: Thu Mar 05, 2026 3:04 pm
by MicroController
Is UART1 accessible for the WROOM module?
Sure, why not?
Re: ESP32-C5-WROOM and UART1
Posted: Thu Mar 05, 2026 9:09 pm
by rtborg
The WROOM module
datasheet has a Pin Description table at page 13 which mentions LP UART and UART0, but not UART1.
Re: ESP32-C5-WROOM and UART1
Posted: Fri Mar 06, 2026 12:42 am
by nopnop2002
from
https://documentation.espressif.com/esp ... eet_en.pdf.
5.2.1.1 UART Controller
ESP32-C5 has three UART interfaces, i.e. UART0, UART1, and LP UART. All the three interfaces provide
hardware flow control (CTS and RTS signals) and software flow control (XON and XOFF).
Re: ESP32-C5-WROOM and UART1
Posted: Fri Mar 06, 2026 7:35 am
by MicroController
You can
route the UART signals to any available IO pins as desired.
Re: ESP32-C5-WROOM and UART1
Posted: Mon Mar 09, 2026 8:59 pm
by rtborg
Thanks, that's much clearer now.