Hi ESP_houwenxiang,

As you can see in the code, in segment 1 there is always a END command after each read operation.

It is done through " I2C[i2c_num]->command[g_cmd_index_use+1].op_code = I2C_CMD_END; "

What we see is the SDA line behaves erratically during the 2nd read operation of the segment ...

Hello ESP_houwenxiang

As you can see there is a END command after each Read command in segment 1. Please check the code.

// Segment 1
i2c_master_read(cmdlink, &rx_data[1], 2, 0x0);
i2c_master_read_byte(cmdlink, &rx_data[3], 0x1);
i2c_master_stop(cmdlink);

cmd = &g_cmd_desc[g_cmd_index_use ...