Hi All,

For one of my projects I am using MQTT client, PPPoS in esp-idf version 4.3.1. The network interface is provided by the Quectel Module EG91
Facing a problem where in my mqtt client is unable to to get the host name some times. With reboots ( in some cases it is >50) the system is able to ...

Hi All,

I am also facing the same issue
"I (183572) esp_image: segment 0: paddr=00110020 vaddr=3f400020 size=2fcf4h (195828) map
I (183652) esp_image: segment 1: paddr=0013fd1c vaddr=3ffbdb60 size=002f4h ( 756)
I (183662) esp_image: segment 2: paddr=00140018 vaddr=400d0018 size=c9828h (825384) map ...

Yes I did this exercise of deleting the build folder altogether & cleaning the project.

Also tried executing build directly from the command prompt

Best Regards,
Pradeep

Hi,

The code is compiled in esp-idf 4.0 but is not compiling in version 4.3.1, using fresh setup on a new m/c as per the directions for the windows installer. I would appreciate if someone can look into this. The errors reported are for blufi api(s) linking ( PS if I try to create a new blufi ...

I switched back to previous version of eclipse (2020-06) & was able to compile.
-Pradeep

Hi,
Installed eclipse plugins as per the directions provided in the installation procedure. Was able to install the tools & create a project from the templates. But compilation gives error "CDT Code builder error".

There was a thread initiated on the discussion forum in this regard, but there was ...

Was there any solution for this problem reported earlier.
I have installed the eclipse environment from scratch as per the procedure, created an example project from the template & compilation results exactly in the same error

"Errors occurred during the build.
Errors running builder 'CDT Core ...

I think on ESP32-Wrover Kit, IO-32 & 33 are not available, as they are connected to some crystal. This was confirmed after when I tried to use them in GPIO example & reviewing the dev kit schematic thereafter.

Best Regards,
Pradeep

Any input regarding this??

-Pradeep

I am using the code below for initialization as shared by David Antliff for one wire bus via RMT channel
Here:
gpio_num =33
tx_channel = RMT_CHANNEL_1
rx_channel = RMT_CHANNEL_0


static owb_status _init(owb_rmt_driver_info *info, gpio_num_t gpio_num,
rmt_channel_t tx_channel, rmt_channel_t rx ...