I don't know what you mean.
But you may have to configure the GT911 to use its "falling edge" interrupt mode.

Really ? I can do that ? that will solve the problem for sure. Let me check the datasheet.

Hello,

I have this RGB 7" display I purchased from aliexpress, it runs ESP32-S3 and I believe ST7262 RGB display driver.

The problem is in the initialization of the GT911 touch driver.

If the interrupt pin is configured as input, it goes to HIGH all the time and then the GT911 is locked into ...

There's nothing official about that library, and it has not been updated in 3 years.

But it's in the official arduino list, I believe that a library must be approved and confirmed to be uploaded on the site.

If the physical resolution of the device is 480x320
The phesical resolution of my ...

Hi,

I have a problem with the resolution of the touch coordiation.

The display is 800x480 but the max resolution I can get is the default 480x320.

I'm using the official Arduino TAMC_GT911 library.
https://www.arduino.cc/reference/en/libraries/tamc_gt911/

Any suggestions of how to change the ...

I recommend to you to remove all environment variables you set manually. They will cause you trouble now or later.

It is advised to use the Windows installer (https://docs.espressif.com/projects/esp-idf/en/release-v5.0/esp32/get-started/windows-setup.html) which will set up your environment ...

Pulling IO0 to GND worked with me, the system must enter boot mode for reflashing.

Hi,

I have both ESP32-3248S035C & ESP32-8048S043C.

I was able to program ESP32-3248S035C easily on

https://suchmememanyskill.github.io/CYD-Klipper/

and

https://install.openhasp.com/

but ESP32-8048S043C isn't programming.

even on arduino ide, I can't upload a simple blink code

In arduino ...

Yep, solved my problem on windows 10 too

Thanks man !

Hi,

I'm using a simple ESP32 devkit with a 4" TFT module.

I started working on a polling code, but the button press response isn't immediate, I have to press it several to many times to get the right response. I don't know what I'm doing wrong but I used the same code provided in the library ...

Hi,

I'm just searching for the definition of function. I searched in the core libraries but didn't find it.

I just found its calls to millis and micros in

esp32-hal-misc.c

and that's all.