VSCODE settings for ESP32-S3

[orbitcoms]

Hi,
This is related to my last post but now I have changed the wiring connection.
I have ESP32-S3-DEVKIT and have connected +5, GND, D- and D+ to USB port on my Windows PC.
The kit shows up under "Universal Serial Bus Device" in Windows device list as "Espressif CDC Device"

However, I cannot get my code to download to flash.

I selected the S3 chip and then "built-in USB JTAG"

After build and compile I get prompted to start OCD. When I select YES I get error "could not find or [Open OCD]