Serial.print on Adafruit ESP32S3 Metro board

[PCRiscV]

I am using Arduino as an IDF component and I am able to run code on the Metro board. I can see the ESP_LOGx messages in the "idf.py monitor" window, but I am not seeing the Serial.print() output? Where is Serial configured. I would like the Serial.print to go to the USB out, same as ESP_LOG.

Thanks

[lbernstone]

https://docs.espressif.com/projects/ard ... t-printing

[PCRiscV]

Thanks, I see that but I am trying to build my app with the IDF tools (Arduino is installed as a component) but I cannot find the right setting. I get the expected result if I use the Arduino IDE, I get the expected results.

Thanks

[lbernstone]

That link also shows the define macros you should set before you call initArduino that match the settings from the tools menu.

[PCRiscV]

Ok that's easy to do. Do I define the macro before the call to initArduino, or should the #define be used to compile the whole component? When looking at HardwareSerial.h it looks like the define are needed when compiling the components.

Thanks

Code: Untitled.c Select all

#if !defined(NO_GLOBAL_INSTANCES) && !defined(NO_GLOBAL_SERIAL)

#ifndef ARDUINO_USB_CDC_ON_BOOT

#define ARDUINO_USB_CDC_ON_BOOT 0

#endif

#if ARDUINO_USB_CDC_ON_BOOT  //Serial used from Native_USB_CDC | HW_CDC_JTAG

#if ARDUINO_USB_MODE         // Hardware CDC mode

// Arduino Serial is the HW JTAG CDC device

#define Serial HWCDCSerial

#else  // !ARDUINO_USB_MODE -- Native USB Mode

// Arduino Serial is the Native USB CDC device

#define Serial USBSerial

#endif  // ARDUINO_USB_MODE

#else   // !ARDUINO_USB_CDC_ON_BOOT -- Serial is used from UART0

// if not using CDC on Boot, Arduino Serial is the UART0 device

#define Serial Serial0

#endif  // ARDUINO_USB_CDC_ON_BOOT

// There is always Seria0 for UART0

extern HardwareSerial Serial0;

#if SOC_UART_NUM > 1

extern HardwareSerial Serial1;

#endif

#if SOC_UART_NUM > 2

extern HardwareSerial Serial2;

#endif

#endif  //!defined(NO_GLOBAL_INSTANCES) && !defined(NO_GLOBAL_SERIAL)

[PCRiscV]

If I define:

target_compile_options(${COMPONENT_TARGET} PUBLIC
-DARDUINO=10812
-DARDUINO_${idf_target_for_macro}_DEV
-DARDUINO_ARCH_ESP32
-DARDUINO_BOARD="${idf_target_caps}_DEV"
-DARDUINO_VARIANT="${CONFIG_ARDUINO_VARIANT}"
-DARDUINO_USB_CDC_ON_BOOT=1
-DARDUINO_USB_MODE=0
-DESP32)

Then I get compilation errors:

/HardwareSerial.h:350:16: error: 'USBSerial' was not declared in this scope; did you mean 'Serial'?
350 | #define Serial USBSerial

when compiling .../cores/esp32/chip-debug-report.cpp:290:3: note: in expansion of macro 'Serial'