ESP32C3 SuperMini Wont Run

[Barbeta]

Hi everyone,

I’m having some issues with an ESP32-C3 SuperMini. Sometimes, when I press the button, everything works fine, but other times the ESP just doesn’t start, out of about 10 attempts, it only works around 6 times.

I’m not sure if this is a wiring problem or if I’m missing something in the setup. I’ll attach the circuit diagram and the ESP pinout for reference.

Any help or suggestions would be greatly appreciated!

Schematic_New-Project_2025-09-16.png (74.48 KiB) Viewed 1584 times

esp32c3supermini.jpg (68.88 KiB) Viewed 1584 times

[lbernstone]

gpio9 is the boot button. If this is low during boot, the chip will be waiting for a firmware upload. You should not connect it to anything that may be active during boot (even something that may just be hanging onto some extra capacitance).