ESP32-P4 is not booting

[PepitoGrillo]

Hello there!

I have a custom board, with an integrated ESP32-P4. Despite powering the board, the IC is not consuming any current and it's not sending any message via the UART interface.

Attatching the schematic.

I also have a really similar board (same schematic, but I messed with the RX and TX pins). The board powered fine and was consuming some current.

Can't seem to find a logical solution to this part.

Do you guys have any idea?

Thank you very much!

[lichurbagan]

Since you're saying that you 'messed with the tx, rx pins ' kindly check the other traces. Maybe you cut one or two other traces by mistake.

[PepitoGrillo]

Maybe I didn't explain good enough.

I first manufactured a board. It had the RX and TX pins messed up. But the ESP32 booted, and was sending some messages after booting.

I then manufactured another board. Apparently, with the same schematic (only the RX and TX changed). And this second board is not booting.

I guess there is something not ok in both PCBs. Maybe some floating pin, and with the first board it behaves different than the second.