ESP32 Deep sleep power consumption

[epicac]

Hi guys,

recently I bought a couple of ESP32 Dev boards:

esps.jpg (144.72 KiB) Viewed 4664 times

The upper one has already power indication diod soldered off. But for some reason in deep sleep the power consumption is 9.7mA (resp. 11.2mA with the diod on).
I wanted to use a 3.7V 700mAh LiPo battery but it's drained in 3 days. Battery is connected using VIN, GND pins. The test code is just this:

Code: Untitled.cpp Select all

#define uS_TO_S_FACTOR 1000000

#define TIME_TO_SLEEP  30



void setup() {

  esp_sleep_enable_timer_wakeup(TIME_TO_SLEEP * uS_TO_S_FACTOR);

  esp_deep_sleep_start();



}



void loop() {

}

Do you guys have any idea?
Thanks

[Sprite]

If any, replace the AMS1117 LDO, they're notoriously inefficient.

[epicac]

Thanks for the answer. I have a couple of HT7333s at home, so I'll try that!

[Sprite]

You can try, but do note that those LDOs are limited to 250mA. The ESP32 needs a minimum of 500mA on WiFi initialization, otherwise it'll brown out. (If you want to test it anyway: a hacky solution would be to put two HT7333 chips in parallel.)

[DavidL]

Hello
I take advantage of this topic, to know LDO recommendation. for full use. ?