ESP32 Forum

Code: Untitled.txt Select all

 USAGE ➜  cargo run --release

    Finished `release` profile [optimized] target(s) in 0.29s

     Running `espflash flash --monitor target/xtensa-esp32s3-espidf/release/s3-test`

[2025-02-27T15:46:18Z INFO ] Detected 2 serial ports

[2025-02-27T15:46:18Z INFO ] Ports which match a known common dev board are highlighted

[2025-02-27T15:46:18Z INFO ] Please select a port

[2025-02-27T15:46:19Z INFO ] Serial port: '/dev/cu.usbserial-110'

[2025-02-27T15:46:19Z INFO ] Connecting...

[2025-02-27T15:46:22Z INFO ] Using flash stub

Chip type:         esp32 (revision v1.1)

Crystal frequency: 40 MHz

Flash size:        4MB

Features:          WiFi, BT, Dual Core, 240MHz, VRef calibration in efuse, Coding Scheme None

MAC address:       3c:8a:1f:d5:22:6c

App/part. size:    406,512/4,128,768 bytes, 9.85%

[00:00:01] [========================================]      17/17      0x1000                                                                                   [00:00:00] [========================================]       1/1       0x8000                                                                                   [00:00:24] [========================================]     234/234     0x10000                                                                                  [2025-02-27T15:46:51Z INFO ] Flashing has completed!

Commands:

    CTRL+R    Reset chip

    CTRL+C    Exit



ets Jun  8 2016 00:22:57



rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)

configsip: 0, SPIWP:0xee

clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00

mode:DIO, clock div:2

load:0x3fff0030,len:7104

load:0x40078000,len:15576

load:0x40080400,len:4

ho 8 tail 4 room 4

load:0x40080404,len:3876

entry 0x4008064c

I (31) boot: ESP-IDF v5.1-beta1-378-gea5e0ff298-dirt 2nd stage bootloader

I (31) boot: compile time Jun  7 2023 07:48:23

I (33) boot: Multicore bootloader

I (37) boot: chip revision: v1.1

I (41) boot.esp32: SPI Speed      : 40MHz

I (45) boot.esp32: SPI Mode       : DIO

I (50) boot.esp32: SPI Flash Size : 4MB

I (55) boot: Enabling RNG early entropy source...

I (60) boot: Partition Table:

I (64) boot: ## Label            Usage          Type ST Offset   Length

I (71) boot:  0 nvs              WiFi data        01 02 00009000 00006000

I (78) boot:  1 phy_init         RF data          01 01 0000f000 00001000

I (86) boot:  2 factory          factory app      00 00 00010000 003f0000

I (93) boot: End of partition table

I (97) esp_image: segment 0: paddr=00010020 vaddr=3c050020 size=03fd8h ( 16344) load

[b]E (106) esp_image: Segment 0 0x3c050020-0x3c053ff8 invalid: bad load address range

E (114) boot: Factory app partition is not bootable

E (120) boot: No bootable app partitions in the partition table[/b]

ets Jun  8 2016 00:22:57



rst:0x3 (SW_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)

configsip: 0, SPIWP:0xee

clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00

mode:DIO, clock div:2

load:0x3fff0030,len:7104

load:0x40078000,len:15576

load:0x40080400,len:4

ho 8 tail 4 room 4

load:0x40080404,len:3876

entry 0x4008064c

I (60) boot: ESP-IDF v5.1-beta1-378-gea5e0ff298-dirt 2nd stage bootloader