ESP32 Forum

Hi all,

I have a ESP-32 C3 that works perfectly fine, but I cannot connect to the AP after a fresh installation.

Once I erase and reinstall ESP Presence, the device does not find the Wifi AP for me to connect to to change the properties.

The device works because after I disconnect and reconnect the power, I can flash my own config file to it and it connects to my network.

I can just never see it as an AP to change settings.

Is there another way to change the settings once flashed with my own config?

Thanks

If you can flash a working config, you can modify the settings in the config.json file before flashing. This allows you to set SSID, password, MQTT settings, and other parameters.