Looking for Guidance on ESP32-S3 Touch LCD 7 Setup on macOS (M1)
Posted: Wed Nov 19, 2025 3:09 pm
I’m working on a project using an ESP32-S3 Touch LCD 7. I’m setting it up on macOS Tahoe 26.1 (M1). I’m not asking for troubleshooting, just guidance on the correct setup steps for this board.
I want to confirm:
• Which USB/serial driver is recommended for the S3 on macOS
• Whether Arduino IDE or PlatformIO is preferred for this module
• Which libraries are required for the Touch LCD 7
• Any official documentation or GitHub examples for this display
• Known macOS compatibility notes for the S3
If anyone has experience with this exact module, I’d appreciate pointers or links.
Thanks in advance!
I want to confirm:
• Which USB/serial driver is recommended for the S3 on macOS
• Whether Arduino IDE or PlatformIO is preferred for this module
• Which libraries are required for the Touch LCD 7
• Any official documentation or GitHub examples for this display
• Known macOS compatibility notes for the S3
If anyone has experience with this exact module, I’d appreciate pointers or links.
Thanks in advance!