Hi Ves011,

it looks like this was a good hint. Once I have connected GPIO 19 (white USB cable) and GPIO20 (green USB cable) I was immediately getting a serial output. I used the USB-C in parallel to "power" the PCB.

Learn so far:

- The former upload was successful as I can see the old program ...

I setup the Arduino IDE as shown in the screenshot + the build and upload was successful at least according to the screenshot.

I tried to keep the code as clean as possible.

void setup() {

Serial.println("Hello World");
}

void loop() {
}


however I also tried it with Serial-println in the ...

Hi there,

I have designed a custom PCB (my first one) with an ESP32, UART Bridge and some sensors.

I am able to connect it, and even to upload some code (with pushing the boot button).

However u don’t get any signal feedback on the serial.monitor. I tried different settings in Arduino IDE and ...

Hi ESP_Sprite,

thanks again for your help. That was exactly the problem! Great. Now I can proceed.

Oh okay, thank you! I will try that out. Keep you updated if this helped

Hello,

i have created a custom board using an esp32s3-wroom and an cp210 uart bridge.

when I try to upload a firmware / program I get the error message:

_____________________

Sketch uses 233525 bytes (17%) of program storage space. Maximum is 1310720 bytes.
Global variables use 18244 bytes (5 ...